FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
STAND LEGS
1.Assemble the longer bottom bracket (A) Fig. 6, to the inside of two table legs (B) as shown. Align the holes in the longer bottom bracket (A) Fig. 6, with the holes in the table legs (B). Insert a
2.Assemble the other stand bracket (A) Fig. 6, to the remaining two table legs (B) in the same manner.
3.Assemble the two shorter stand brackets (D) Fig. 7, to the leg assemblies (B) in the same manner as the longer bottom bracket was assembled.
4.Assemble a plastic foot (E) Fig. 7, to the bottom of each leg as shown.
STAND TO SAW
TO PREVENT PERSONAL INJURY OR
DAMAGE TO THE MACHINE, WE SUGGEST THAT THE STAND BE MOUNTED TO THE SAW AS FOLLOWS:
1.Place the saw upside down on a sturdy work bench or floor as shown in Fig. 8.
TO PROTECT THE TABLE TOP, PLACE SOMETHING BETWEEN THE TABLE TOP AND THE WORK BENCH OR FLOOR, SUCH AS A PIECE OF CARDBOARD, CARPET ETC.
NOTE: Make certain the shorter stand brackets (D) Fig. 8, are at the front and rear of the saw as shown.
2.Align the eight holes in the bottom of the saw cabinet with the eight holes in stand legs. Place a 5/16" flat washer on a
3.Assemble bracket (H) Fig. 9, to the inside of front leg assembly (D) as shown. Align holes in bracket (H) with holes in front leg assembly (D). Place a 5/16" flat washer on a
B
B
A
Fig. 6
B
D
B
D
E
Fig. 7
Fig. 8
H
DD
Fig. 9
11
