OUTFEED SUPPORT
1.Loosely fasten both brackets (A) Fig. 31, to the bottom left side of the saw table as shown, using two M6x1x15mm hex head screws (B) and M6.1 lockwashers (C). Assemble two remaining brackets to the bottom right side of saw table in the same manner.
A
C
B
2.Insert rod (D) Fig. 32, through holes in brackets (A) as shown. Then thread and tighten one
F
Fig. 31
G
D
A
3.Insert rods (D) Fig. 33, into larger holes (H) in outfeed support (J) as shown.
4.Secure outfeed support (J) Fig. 34, to rods (D) using two
(K) as shown.
5.Push entire outfeed support assembly (J) Fig. 35, in until it contacts splitter/guard assembly (L) as shown. Then tighten all outfeed support mounting hardware.
D
K
J
K
Fig. 34
E
Fig. 32
J
H
D
H
Fig. 33
L
J
Fig. 35
17
