STORAGE
Before you store the air compressor, make sure you do the following:
1.Review the Maintenance section on the preceding pages and perform sched- uled maintenance as necessary.
2.Set the On/Off switch to "Off" and unplug unit.
3.Turn the regulator counterclockwise and set the outlet pressure to zero.
4.Remove the air tool or accessory.
5.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately 20 PSI. Release safety valve ring.
6.Drain water from air tank by opening drain valve on bottom of tank.
Risk of Bursting. Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing
a risk of air tank rupture.
7.After the water has been drained, close drain valve by turning clockwise. NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.
8.Protect the electrical cord and air hose from damage (such as being stepped on or run over). Wind them loosely around the compressor handle.
9.Store the air compressor in a clean and dry location.
SERVICE
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our web- site at
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about
You can also write to us for information at
ACCESSORIES
A complete line of accessories is available from your
Since accessories other than those offered by Porter‑Cable•Delta have not been tested with this product, use of such accessories could be hazardous. For safest operation, only Porter‑Cable•Delta recommended
accessories should be used with this product.
15 - ENG | N003568 |