CAUTION:
Due to weight of each thin node (under 18 Kg [40 lbs]), use care when removing and replacing thin
nodes above shoulder height. (
SPSFC005
)
CAUTION:
The wide node weight may exceed 32 Kg (70.5 lbs). (
SPSFC006
)
CAUTION:
Do not open more than one wide node or switch assembly drawer at a time. (
SPSFC007
)
CAUTION:
Make sure the stability foot and wheel chocks are installed on the frame. These are required to
maintain frame balance and position during service operations. (
SPSFC008
)
CAUTION:
Outer edges of chassis may be sharp. Care must be taken when removing and installing chassis.
(
SPSFC009
)
CAUTION:
The ground strip may have sharp edges. (
SPSFC010
)
CAUTION:
Do not remove wide nodes or switch assemblies from the mounting slides. Caution must be
observed when working with mounting slides to prevent pinched fingers or accidental release of
the unit. (
SPSFC011
)
CAUTION:
Do not remove the drawer case mounting screws at the bottom of both sides. (
SPSFC012
)
CAUTION:
Once the latch is released, push the drawer closed. Do not pull, as the drawer may disengage from
the rails, creating a safety hazard. (
SPSFC013
)
CAUTION:
Due to the weight of each wide node, use care when sliding and closing wide processor nodes
above shoulder height. (
SPSFC014
)
CAUTION:
vWhen moving frames into position, team members should work together. Using one person on
each corner of the frame can prevent strain.
vIn raised floor installations, mechanically safe moldings should be installed around floor
cutouts. Extreme caution should be used when moving frames during installation or removal
because of the proximity of floor cutouts to casters. (
SPSFC015
)
xii RS/6000 SP: SP Switch2 Service Guide