![](/images/new-backgrounds/1158692/15869223x1.webp)
Before you connect the power cable of this product to ac power, verify that the power receptacle is correctly grounded and has the correct voltage. (SPSFD004)
DANGER
During an electrical storm, do not connect or disconnect any cable that has a conductive outer surface or a conductive connector. (SPSFD005)
DANGER
Switch off power and unplug the machine power cable from the power receptacle, before removing or installing any part that is connected to primary power. (SPSFD006)
DANGER
To prevent possible electrical shock during machine installation, relocation, or reconfiguration, connect the primary power cable only after connecting all electrical signal cables. (SPSFD007)
DANGER
High voltage present. Perform ″Lockout safety procedures″ to remove primary power to the frame. (SPSFD008)
DANGER
High voltage present. Perform ″Lockout safety procedures″ to remove primary power to the frame (and
DANGER
High voltage present at test points. Use high voltage test probes. (SPSFD010)
DANGER
High energy present. Do not short 48V to frame or 48VRtn. Shorting will result in system outage and possible physical injury. (SPSFD011)
DANGER
If a unique power module fails, all LEDs will be off. The high voltage LED will be off even though the high voltage is still present. (SPSFD012)
DANGER
The remaining steps of the procedure contain measurements that are taken with power on. Remember that hazardous voltages are present. (SPSFD013)