Porter-Cable N020227 Troubleshooting Maintenance, Transportation and Storage, Repairs Cleaning

4.Position the new abrasive pad to the back-up disc, and center the hole of the disc on the hub (B) Fig. 10 of the back-up disc.

5.Position the large metal washer (B) Fig. 9, and the retaining nut (A) Fig. 9, to the sander.

6.Rotate the retaining nut clockwise to hand tighten (while holding the abrasive pad as described in step 1).

A

C

B

Fig. 9

TRANSPORTATION AND STORAGE

Fig. 10

A

B

Keep the sander dry during transport and storage. Protect the abrasive pad. Contact with another object may deform the pad, causing it to sand unevenly. If you cannot protect the pad during transport or storage, remove and store it separately.

TROUBLESHOOTING

For assistance with your tool, visit our website at www.deltaportercable.com for a list of service centers, or call the PORTER-CABLE Customer Care Center at

(888)-848-5175.

MAINTENANCE

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS wear certified safety equipment:

•ANSI Z87.1 eye protection (CAN/CSA Z94.3)

•ANSI S12.6 (S3.19) hearing protection

•NIOSH/OSHA/MSHA respiratory protection.

REPAIRS

For assistance with your tool, visit our website at www.deltaportercable.com for a list of service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.

CLEANING

Periodically blowing dust and chips out of the motor housing using clean, dry compressed air is a suggested maintenance procedure. To reduce the risk of seri- ous personal injury, ALWAYS wear ANSI Z87.1 safety glasses while using compressed air.

14