Porter-Cable PC1800AG instruction manual inch 115mm Sanding Flap Discs

4-1/2 inch (115mm) Sanding Flap Discs

Type 27 guard

hubbed sanding

flap disc

4-1/2 inch (115mm) Cutting Wheels

Type 1 guard	Type 1 guard
backing flange	backing flange
abrasive cutting wheel	diamond cutting wheel
clamp nut	clamp nut

Type 27 guard

unthreaded backing

flange

non-hubbed sanding

flap disc

threaded clamp nut

Operation

Switch (Figure H &I)

Lock-off Button and Trigger Switch

Your cut-off tool is equipped with a lock-off button (2).

To lock the trigger switch (1), move the lock-off button (2) to the rear as shown in Figure H. When the lock-off button is moved to this position, the trigger switch is locked.

Always lock the trigger switch when carrying or storing the tool to eliminate unintentional starting.

To unlock the trigger switch, move the lock-off button to the front as shown in Figure I . When the lock-off button is moved to this position, the trigger switch is unlocked.

Pull the trigger switch (1) to turn the motor ON. Releasing the trigger switch turns the motor OFF.

NOTE: This tool has no provision to lock the switch in the ON position, and should never be locked ON by any other means.

: Hold the side handle (5) and body of the

tool firmly to maintain control of the tool at start up and during use and until the wheel or accessory stops rotating.

H

I

14