Wake up scanner
When the scanner enters the sleep mode, pressing this
switch can wake the scanner up. The sleep mode
feature can be programmed using the menu labels
from the Programming Guide.
NOTE: The default time-out value is set to 10
minutes after laser slept, 30 minutes after motor slept.
When the scanner is in sleep mode, the LED inside
function button is intermittently flashing Blue.
Function Button
(Embedded with the LED
Indicator)
Single -line mode
Press and release the button will activate single line
scan mode if the scanner is not seated in the stand.
Mounting Screw Holes To fix the scanner onto the bracket of SK-200 kit.
Interface Cable Connector For USB interface cable connection.
Operation Status
When the scanner powers up, the buzzer gives four beeps and the LED indicator
in function button glows.
Present a known-good test barcode to the scanner. The scanner should issue a
short beep and the LED should flash red momentarily.
Note: Refer to LED Indications and Beeper Indications sections for operation status or
refer to the section on Troubleshooting Guide for diagnostic tips.
Supported Bar Code Types
Supported Bar Code (Symbol) Type Default Status
UPC, EAN, JAN Enabled
ITF 2 of 5 Disabled
Code 39 Enabled
Codabar Disabled
Chinese Post Code Disabled
MSI / PLESSY Disabled
Code 93 Disabled
Code 128 Disabled
Code 32 (Italian Pharmacode) Disabled
ISSN / ISBN Disabled
EAN-128 Disabled
Pa
g
e 4