Poulan 532140602, CR38C Use Hardware - Group a, See Figs a & 2B, Use Hardware - Group B

1	MOWER DECK BAFFLE (See Fig. 1)
	Use Hardware - - GROUP "A"

1.Raise your tractor mower deck to its highest position.

2.Install the hex bolt, and locknut through mower deck baffle and tighten securely.

		HEX BOLT
LOCKNUT
MOWER DECK BAFFLE		02342
	FIG. 1
2	REAR MOUNTING BRACKET
	(See Figs. 2A & 2B)

NOTE: If your tractor already has four (4) shoulder bolts installed on the rear drawbar, simply hang the mounting bracket, lanced tabs towards bottom, on the bolts. Discard hardware group "B" and disregard the remaining Step 2 instructions.

SHOULDER

02462 BOLTS

LANCED TABS

TOWARD BOTTOM

FIG. 2A

If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below.

Use Hardware - - GROUP "B"

1.Using the four formed holes in the drawbar, install the four shoulder bolts as shown and tighten securely.

2.Hang the mounting bracket, lanced tabs towards bottom, on the bolts.

SELF

TAPPING

SHOULDER

BOLTS

0 246 1

LANCED TABS

TOWARD BOTTOM

FIG. 2B

3	COVER SEAL (See Fig. 3)
	No hardware required

1.Align mark on seal with mark at cover opening.

2.Work seal into opening so cover sits between flanges of seal.

ALIGNMENT

MARKS

	02085
	COVER SEAL
	FIG. 3
4	SUPPORT POST (See Fig. 4)
	Use Hardware - - GROUP "C"
	CAUTION: Container support is spring
	loaded and locked to the cover. Handle
	cover assembly carefully so as not to
	unlatch the cover from the container
	support.

1.Rotate cover assembly onto its side as shown.

2.Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely.

CARRIAGE

BOLTS

SUPPORT

POST

02091

LOCKNUTS

FIG. 4

7