5 | MOUNTING TO TRACTOR (See Fig. 5) |
Use Hardware - - GROUP "D" |
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor.
1.Raise seat on tractor to allow assembly to be mounted.
2.With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket.
3.Line up holes in mounting bracket with holes in support post and insert bracket support pin.Secure with retainer spring.
4.Unlatch and open cover.
5.Install the three (3) tubing end caps onto container support.
6.Tap each end cap onto container support tubes to seat securely.
BRACKET | COVER ASSEMBLY |
SUPPORT PIN |
|
6 | CONTAINER ASSEMBLY (See Fig. 6) |
No hardware required |
1.Place bottom half inside of top half, as shown.
2.Place one foot inside bottom half and lift top half to meet bottom half.
3.Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT:BEFORE LOCKINGTHETABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAPTO FORM SEAL AS SHOWN IN INSET.
4. Repeat for other containers.
CONTAINER
BOTTOM HALF
02089
CONTAINER
TOP HALF
END CAP
SUPPORT POST
LANCED TABS
RETAINER
SPRING
02096
| 39 | |
| 027 | |
| PRESS TOGETHER | |
CONTAINER | TO FORM SEAL | |
WHILE LIFTING | ||
TOP HALF | ||
TOP HALF | ||
|
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 6
ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
MOUNTING BRACKET
02097
FIG. 5
8
