7 CONTAINER MOUNTING (See Fig. 7)
No hardware required
1.Install one container to left side first with warning to outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container at center support.
2.Close cover and lock latch handle over center support tube.
DEFLECTOR SHIELD
WASHER
MOWER DECK
BAFFLE
COVER LATCH
HANDLE
CONTAINER
WARNING
GN NI | RWA |
|
CONTAINER
HANDLE
02082
FIG. 7
CENTER
SUPPORT
TUBE
CONTAINER WARNING
|
| 02343 |
| WING NUT | HEX BOLT |
|
| |
|
| FIG. 8 |
9 | CHUTE LATCH ASSEMBLY | |
(See Fig. 9) |
| |
Use Hardware - - GROUPS "F & G"
1.Assemble latch pin to upper chute, as shown.
2.Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.
3.Tighten all hardware securely.
| WASHERS | |
#10 X | 3/16 X 3/4 X 16 | |
GA. | ||
| ||
| SPLIT | |
| SPACER | |
UPPER CHUTE |
|
8 | LOWER CHUTE (See Fig. 8) |
Use Hardware - - GROUP "E" |
1.Raise and hold deflector shield in upright position.
2.Slide back edge of chute over rear corner of mower deck and pivot forward.
3.Align slot in lower chute with hex bolt in mower deck baffle and close chute over deck openning.
4.Secure with washer and wing nut.
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
| ACORN NUT |
#10 X 5/8" |
|
SCREW | RUBBER |
| LATCH |
LOWER CHUTE |
|
| WELD |
| NUT |
WASHER | 0 |
3/16 X 3/4 X 16 GA. | 2102 |
| |
| LOCK WASHER |
FIG. 9
9
