!WARNING
ALWAYS STAND AT A SAFE DISTANCE AWAY FROM THE SPINNER WHILE OPERATING ALWAYS WEAR EYE PROTECTION WHEN OUTSIDE OF THE TRUCK CAB WHILE SPREADER IS RUNNING.
B.Spread pattern depends on baffle settings and spinner RPM. Maximum spread width is 30 ft.
1.Speeding up or slowing down the engine will increase or decrease spread pattern width.
2.Internal baffle adjustments will move the spread pattern to the right or left.
3.External baffle adjustments will block spreading to the right or left side.
DESIRED SPREAD PATTERN | BAFFLE SETTING | |
| INTERNAL | EXTERNAL |
Centered Behind Truck | Both Down | All Three UP |
All Material to the Right | RH - Up | RH - Up |
| LH - Down | LH - Down |
All Material to the Left | RH - Down | RH - Down |
| LH - Down | LH - Up |
Behind Truck and Left | RH - Down | RH - Med. |
| LH - Up | LH - Up |
Behind Truck and Right | RH - Up | RH - Up |
| LH - Down | LH - Med. |
Windrow Behind Truck | RH - Down | All - Down |
| LH - Down |
|
4.External Baffles can be lowered to an intermediate position to baffle down the particles that may otherwise leave the spinner at a high trajectory.
C.CALIBRATION
The average lbs. of salt per gearbox shaft revolution per inch of gate height is 6.7 Ibs.
GATE HEIGHT | AVG. LBS/REV. | AVG. LBS/MIN. | AVG. LBS/MIN. |
|
| AT FULL ENGINE RPM | AT 7 GPM HYD OIL FLOW |
1” | 6.7 | 260 | 200 |
3” | 20.1 | 780 | 580 |
5” | 33.5 | 1300 | 970 |
7" | 46.9 | 1800 | 1350 |
|
|
|
|
8
