Power Acoustik PADVD-220T owner manual Wiring Connections, Location Function

Wiring Connections

Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical connection.

Using the ISO Connector

1.If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.

2.For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit.

3.Cut the connector, connect the colored leads of the power cord to the car battery as shown in the color code table below for speaker and power cable connections.

Location	Function
	Connector A	Connector B
1		Rear Right(+)---Purple
2		Rear Right(-)---Purple/Black Stripe
3		Front Right(+)---Grey
4	Battery 12V (+)/yellow	Front Right(-)---Grey/Black Stripe
5	Auto Antenna/blue	Front Left(+)---White
6		Front Left((-)---White/Black Stripe
7	ACC+/red	Rear Left(+)---Green
8	Ground/black	Rear Left(-)---Green/Black Stripe

**TV antenna is for PADVD-220T only.

Page- 5