8) Place your new battery in the same position/direction and reconnect the wires
red wire-position(+) and black wire negative(-)
9) Please follow steps 5,4 and 3 (in that order) to reconnect the entire unit.
10) Please follow manual instructions in order to properly reconnect your
equipment.
11. Storage
10.1 Storage conditions
Store the UPS covered and upright in a cool , dry location, with its battery fully
charged. Before storing, charger the UPS for at least 4 hours. Remove any
accessories in the accessory slot and disconnect any cables connected to the
computer interface port to avoid unnecessary draining the battery.
10.2 Extended storage
During extended storage in environments where the ambient temperature is -15 to
+30 (+5 to +86 ), charge the UPS‘ s battery every 6 months.
During extended storage in environments where the ambient temperature is +30
to +45 (+86 to +113 ), charge the UPS‘ s battery every 3 months.
12. Troubleshooting
PROBLEM POSSIBLE ACTION TO TAKE
On/test button not
pushed or push too
short
Press the on/test button to power the UPS
and the load
UPS input circuit
break tripped
Reduce the load on the UPS by unplugging
equipment and reset the circuit breaker by
pressing the plunger back in
UPS will not turn on
Very low or no utility
volta
g
e
Check the AC power supply to the UPS with
multimeter
UPS will not turn on or
off
Computer interface
of accessory
problem
Push on/test or off
butto
n
too
s
h
o
r
t
Disconnect the computer interface or
accessory. If the UPS now works normally,
check the interface cable, the attached
computer and the accessory
UPS operates on-
battery even though
normal line voltage is
UPS’s input circuit
breaker tripped
Reduce the load on the UPS by unplugging
equipment and reset the circuit breaker
UPS beeps occasionally Normal UPS operation Normal condition
UPS does not provide TheUPS’ s battery is Charge the battery