Powermate P-RTT-196MD Install the Wheels See Figure, Install the Tines, Install the Tine Shield

Assembly (Continued)

• Save all instructions

A How to Remove Tiller from Carton

1.Remove all parts and packaging components.

2.Use a utility knife to cut all 4 vertical edges and lay the side panels flat around the tiller.

3.Remove any remaining packaging.

4.Remove the two bolts going thru the packing frame and wheel axle holes.

5.Remove the two bolts located underneath the engine that go thru the packing frame and thru the tiller base frame.

6.With a helper, remove the tiller from the packing frame.

B Assembly Instructions

The tiller comes fully assembled except for a few parts. The fol- lowing instructions will help you complete the tiller assembly.

INSTALL THE WHEELS (See Figure 2)

1.Remove the locking pins from the wheel hubs.

2.The tiller wheels are directional. For best performance install the wheels with the tire thread facing the direction as shown.

3.Slide the wheel hub onto the wheel axle.

4.Align the wheel hub hole with the hole in the axle and insert the locking pin.

5.Rotate the locking pin ring to lock the pin in position.

INSTALL THE TINES

1.Check the orientation of the tine blade. The sharp cutting edge should be facing the direction of tine rotation for your tiller.

2.Install the tine assemblies on each tine axle. Secure with M10x50mm bolts and lock nuts. Do not over tighten the tine bolt. This could damage the tine assembly and cause difficulty in removing the tine assembly from the tine axle.

INSTALL THE TINE SHIELD

1.Remove the 4 bolts installed in the tine shield brackets above the transmission housing.

2.Place the tine shield on the bracket and secure with the bolts removed in 1. above.

3.Install the tine shield side guards with the hardware provided.

INSTALL THE DEPTH REGULATOR (See Figure 3)

1.Remove the bolt and knob from the depth regulator lever.

2.Insert the depth regulator into the bottom of the depth regulator bracket.

3.Insert the detent pin thru the bracket and lever.

4.Install the bolt and knob removed in 1. onto the depth regulator lever.

If you need assistance or find any parts missing, CALL TOLL FREE: 1-800-737-2112.

FRONT
Wheel lock pin in tiller operating position
(wheel hub and axle holes)	Figure 2

Dentent Pin

Depth Regulator Bracket

Depth Regulator Lever

Figure 3

Questions? Call Toll Free at 1-800-737-2112 8 Copyright © 2009 MAT Engine Technologies, LLC