Arm Axis
Keep the axis of the arm lubricated with a good quality general purpose grease, inserted through the grease fitting (Figure 18).
Figure 18
Fence
At least once a week, place a light coat of oil on the sliding column of the fence. Also place a drop of oil on each roller pin. See Figure 19.
Figure 19
Troubleshooting
Trouble | Probable Cause | Remedy | |
|
|
| |
| Not connected to power source. | Check power connections. | |
Feeder will not start. |
|
| |
Fuse blown, or circuit breaker tripped. | Replace fuse, or reset circuit breaker. | ||
|
|
| |
| Cord damaged. | Replace cord. | |
|
|
| |
| Belt not situated in correct pulley | Install belt in correct pulley grooves. | |
Feed rate is not | grooves to achieve desired speed. | [page 13] | |
|
| ||
|
| ||
sufficient; or machine | Extension cord too light or too long. | Replace with adequate size and | |
has low power. | length cord. [page 11] | ||
| |||
|
|
| |
| Low current from electrical supply. | Contact a qualified electrician. | |
|
|
|
15
