3.Loosen lock handle (B, Figure 10) and rotate the swivel cone (C, Figure 10) 180- degrees, as shown in Figure 10.

4.Re-tighten lock handle (B, Figure 10).

5.Loosen lock handle (D, Figure 10) and rotate the arm cone as needed until it can slide back onto the horizontal arm. Tighten locking handle (D, Figure 10).

6.Mount the Stock Feeder to the horizontal arm and tighten the screw (A, Figure 10).

Speed Selection

The PF3-JR has four speeds: 13, 26, 33 and 62 feet per minute (or 4, 8, 10 and 19 meters per minute, respectively). Achieving these four speeds is dependent upon the choice and proper position of the gears.

Unplug the stock feeder from power source before changing gears.

To change the position of the gears:

1.Unscrew the knob (Figure 11) and pull off the back cover to expose the gear system, shown in Figure 12.

2.Remove hex nuts and flat washers (A, Figure 12) with a 14mm wrench.

3.Figure 13 shows the relationship of gear position to create each of the four speeds. A similiar chart is affixed to the inside of the back cover on the Stock Feeder.

4.Install new gear configuration, making sure the notch in each gear slides into the keyway of the shaft. Push the gear as far as it will go onto the shaft.

5.Install hex nut and flat washer (A, Figure 12) on each shaft, and tighten.

6.Re-install back cover and tighten knob (Figure 11).

Figure 11

Figure 12

Figure 13

13

Page 13
Image 13
Powermatic PF3-JR operating instructions Speed Selection