PQI P600 manual ™ Connecting with OTG Cable, Connect the OTG cable with the

™Connecting with OTG Cable

Use OTG cable to connect a camera(camcorder) or card reader and download data.

1 Connect the OTG cable with the

USB port of the camera(camcorder) or card reader.

2 Connect the OTG cable with the USB port of the mPack P600.

3 Press the <USB OTG> button on the mPack P600.

-The USB LED of the mPack P600 blinks green and the data saved in the camera, camcorder or card reader is copied into the mPack hard disk drive.

4 When the USB LED is off, separate the USB OTG cable.

Note

Note

●You should use the OTG function when the mPack P600 is turned on. Once you start using the OTG function, the mPack P600's LCD is automatically turned off.

●Use the OTG function in the Search mode of the camera or the camcorder.

●Some cameras or camcorders do not support the OTG function. Refer to the OTG specifications of the camera or camcorder.

●When you download data using the OTG function, the DSK00000 folder is created in the Backup folder of the mPack hard disk drive and the downloaded data is saved in this folder. If the DSK00000 folder already exists, a new folder is created with the name of DSK00001, DSK00002, and so on.

●The USB LED is lit green and does not turned off: The LED may be lit for up to 5 seconds for data operations such as data buffering. If the LED is lit for more than 30 seconds, it means data transmission error. In this case, press the USB OTG button on the mPack. The LED is, then, turned off and the mPack player returns to its initial status (that is the same as the mPack player status before the USB OTG cable is connected to the player). If you press the USB OTG button on the mPack, the data backup is restarted from the beginning.

●The USB LED is lit red: It means a USB device recognition error. In this case, remove the USB OTG cable from the mPack immediately. Reconnect the USB OTG cable.

27