SPEAKER WIRING

Using 16 gauge or larger, run the speaker wires from the amplifier location through the vehicle to the speakers. Observe the same precautions for routing these wires that you followed for running the power and remote turn-on wires. Cut off excess and, using wire strippers, strip 1/4 inch of insulation. Locate the speaker/remote turn-on PowerLock connector. Loosen the four outer screws on top of the connector and insert the Channels 5/6 speaker leads into the end. Check to be sure you've maintained proper polarity before securing each wire.

Speaker PowerLock Connector

Right Speaker negative

Right Speaker positive

Remote turn on

Left Speaker positive

Left Speaker negative

Speaker PowerLock Connector

Right Speaker negative

Right Speaker positive

Left Speaker positive

Left Speaker negative

Speaker/Remote PowerLock

For the front and rear channels, locate the four terminal speaker PowerLock connectors. On your new Pro6800 PowerClass Amplifier, all speaker PowerLocks plug into the amplifier with the screws facing up. Loosen the screws on the top of the blocks and insert the stripped ends of the speaker wires into the end. Double check polarity, secure each wire by tightening the screws, and plug the PowerLock connector into the amplifier with the screws on top.

8

BACK TO CONTENTS

Page 10
Image 10
Precision Power PC6800 specifications Speaker Wiring