Diagram 11
5.Remove the paper backing from one side of the thin pad and press the pad firmly in place onto the flywheel. See Diagram 11.
6.To mount the magnet and reed switch continue with the steps below, Attaching the Magnet and Reed Switch.
Attaching the Magnet and Reed
Switch
For the electronic console displays to operate properly, a magnet and reed switch need to be precisely installed. The magnet is mounted to the flywheel and the reed switch is placed on the side rail. Mounting pads indicate where you need to mount the hardware. Be sure to follow the previous instructions Installing the Mounting Pads before attaching the magnet or reed switch.
To install the magnet and reed switch, take the following steps:
CAUTION: To ensure the integrity of the reed switch, lower the handrails before mounting the reed switch. Allowing excess wire near the flywheel eliminates the possibility that the reed switch will be pulled out of position. If you are not sure how to lower the handrails, refer to your Owner’s Manual.
page 14
