5.Secure the mounting bracket and clamp by inserting the two long screws through the mounting holes. You may need to squeeze the ends of the clamp together to install the screws. See Diagram 3. Tighten the screws into the recessed holes on the mounting plate using the Phillips head screwdriver. Do not over tighten the screws. A gap should remain between the opposite sides of the handrail clamp.
Diagram 4
6.Unwrap the reed switch wire. Route the connector and wire through the hole in the handrail clamp. See Diagram 4.
7.Plug the connector into the receptacle as shown in Diagram 4. Do not force the connection. The connector is designed to engage in one direction only. A tab on the connector and a slot on the receptacle help you determine the proper alignment.
8.Align the back of the console with the mounting bracket and slide the electronic console onto it. Gently pull the excess wire through the hole in the handrail clamp while you slide the console toward the rear of the treadmill.
page 7
