Precor c956, c954 Setting Up the Treadmill, Installation Requirements, Additional Tools Needed

C O M M E R C I A L P R O D U C T S D I V I S I O N

Setting Up the Treadmill

You do not need any special knowledge or experience to set up the treadmill. However, because of its size and weight, you will need to obtain assistance.

INSTALLATION REQUIREMENTS

Follow these installation requirements when installing the treadmill. If you do not install the treadmill according to the following guidelines, you could void the Precor limited warranty.

•Set up the treadmill on a solid, flat surface. Unpack and assemble the treadmill close to where you plan to use it. Make sure that the flat surface under the unit is smooth and level.A level unit is required for the user’s safety and proper operation.

•Provide ample space around the unit. Open space around the unit makes for a safer mount and dismount.

•Fill out and mail the limited warranty card. The serial number can be found on the shipping container or on the label near the power receptacle. Write the serial number onto the Precor limited warranty card found on the back cover of this manual and in the Obtaining Service section on page 7.

•Use the appropriate voltage, dedicated circuit, and grounding as speci- fied on the treadmill. The treadmill is available in both 120-volt and 240-volt models. Refer to the treadmill’s identification label to determine the voltage that your treadmill requires. Both the 120-volt and 240-volt models require a dedicated circuit. A 20 amp circuit is recommended.

CAUTION: Do not use a non-grounded outlet or transformer. Do not remove or otherwise bypass the plug with an adapter. Electrical damage can occur and void the Precor limited warranty if the treadmill is connected to an improper power source. Refer to Grounding Instructions on page 3.

ADDITIONAL TOOLS NEEDED

Obtain the following tools before assembling the treadmill.

❑	Wire cutter	❑	Medium weight string
❑	Bubble level	❑	¹⁄₂-inch box end wrench

❑SAE standard socket set with a ratchet or 8-inch crescent wrench

ASSEMBLY INSTRUCTIONS

Take the following steps to assemble the treadmill.

CAUTION:To avoid injury and ensure your safety, get assistance before moving the treadmill off the pallet. Do not drop the unit.

1.Think about the site and location. Have your assistants help place the shipping carton close to the location where you plan to use the treadmill. Break down the side walls of the shipping carton so that they lie flat. Remove the loose contents.

2.Make sure that the power switch is OFF. Check the ON/OFF power switch on the front of the treadmill. Place the switch in the O (OFF) position. Make sure that the treadmill is not plugged into a power source.

page 10