Selecting a U.S. Standard or Metric Display
The EFX can display measurements in either metric or U.S. standard. The default factory setting is set to display U.S. standard. To change this setting, perform the following steps:
1.At the Precor banner, press and hold ENTER while pressing the following keys in sequence without pause:
RESET, CROSSRAMP ▼, RESISTANCE ▲
Use the arrow keys to select a unit of measure (either METRIC or U.S.).
2.When you are ready, press ENTER to accept the displayed setting. The display indicates the setting is saved. Press RESET to return to the Precor banner.
Note: Changing the display to metric measurements affects the default settings. Distances and the odometer values are converted to and appear in kilometers (KM). Speed appears in kilometers per hour.
Viewing the Software Part Numbers, Odometer, and Hour Meter
The EFX stores the total number of strides and the total number of hours the unit has been in use. You can view this information by performing the following steps:
1.At the Precor banner, press and hold ENTER while pressing the following keys in sequence without pause:
RESET, CROSSRAMP ▲, RESISTANCE ▼
The software part numbers scroll across the center display while the odometer and hour meter scroll across the lower display.
2.Write the software part numbers below. You will need these numbers if you call Customer Support with questions. This information will help rule out any
UPPER: ___________________
LOWER: ___________________
3.When you are ready, press RESET to return to the Precor banner.
Owner’s Manual: Advanced Programming and Troubleshooting | 39 |
