Mount Installation
Before proceeding with the mount installation, you should already have the mounting holes
For ease of installation, it is recommended that two people perform the installation.
WHEN MOUNTING THE AM3, THE SIDE THAT THE SWINGOUT ARM IS LOCATED ON MUST HAVE A LAG BOLT MOUNTED ON AT LEAST ONE SIDE ( FIGURE 4, PAGE 8), TOP AND BOTTOM.
DO NOT OVERTIGNTEN THE LAG BOLTS WHEN ATTACHING THE MOUNT TO THE WALL. IMPROPER INSTALLATION MAY RESULT IN PERSONAL INJURY OR DAMAGE TO PROPERTY
Step 1. After the holes have been
Step 2. Insert four (4) 5/16” x 3” lag bolts (or six (6), depending on your mount location) and washers into the mounting holes and tighten (Figure 6).
Step 3. Before tightening down the lag bolts, place a level (supplied) on the top rail and make sure that the mount is level. Once the mount is level, tighten all of the lag bolts using a 1/2” deep set socket.
5/16” x 3” Lag Bolts and Washers
5/16” x 3” Lag Bolts and Washers
Figure 6
Concrete Mount Installation
The concrete anchors must be used for concrete installation. They can be purchased at your local hardware store.
Step 1. Begin by placing the wall plate into position against the wall, keeping it level.
Step 2. Mark off four holes to be used for securing the mount and place the wall plate aside. Step 3. Next, drill holes using an electric drill and 5/16” masonry bit.
Step 4. Insert a concrete anchor into each hole.
Step 5. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall. Step 6. Once all of the anchors are in place, move the wall plate back into position.
Step 7. Attach the nut onto the threaded shaft that is protruding from the wall. Step 8. Do not tighten until all nuts are in place.
Page 8 | Installation Instructions |
