Solid Surface Installation
Concrete drill bits are commercially available.
Marking | Drill | 3/8” Drill Bit |
|
Pilot Hole
Hammer
Wedge Anchor
Step 1. Place the wall plate against the wall and use a level to make sure the wall plate is level from top to bottom.
Step 2. Use a pencil to mark the location of the mounting holes.
Seated Wedge
Anchor
Wall Plate
Step 6. Place the wall plate over the wedge anchors once the wedge anchors have been correctly inserted into the mounting surface.
Step 3. Use a 3/8” drill bit to drill the mounting holes where the marks were made with a pencil.
Nut and Washer
Socket
Wall Plate
Step 7. Place the flat washer and nut onto the wedge anchor and tighten using a socket and socket wrench. Do not overtighten.
Step 8. Insert and gently tap the wall plate covers into place.
Step 4. Once the holes have been drilled, place the concrete wedge anchors into the hole. Using a hammer, gently tap into place.
Step 5. Once the wedge anchors have been inserted into the mounting holes, remove the nut and flat washer from the wedge anchor.
Wall Plate
Covers
Completed Installation
Page 6
