Premier Mounts WMK-027 Throw Distance Calculation, Front Mounted Lens, Rear Mounted Lens

WMK-027

MAKE SURE THE PROJECTOR ARM IS FULLY SEATED BEFORE RELEASING THE UNIT.

Lock Mounting Point

M5 x 12mm Security Head Screw

Screwdriver/Security Wrench

Step 4. Locate the two (2) lock mounting points on the projector arm. These two points will be aligned with the lock mounting points on the wall plate.

Step 5. Using a security wrench, insert and tighten two (2) M5 x 12mm security head screws.

DO NOT OVERTIGHTEN THE SCREWS.

Throw Distance Calculation

Please review the Operator’s Manual that came packaged with your projector before attaching the upper mounting bracket. The correct throw distance (the distance from the projector to the screen) must be determined prior to mounting the projector.

Step 1. Refer to the projectors Users Manual to determine the distance from the lens to the front of the screen.

Step 2. Measure the distance from the front of the lens to the center of the PDS-PLUS (see diagram).

Front Mounted Lens
For front-mounted lenses, add	distance (Y)
to distance listed in projector	Users Manual.
Rear Mounted Lens

For rear-mounted lenses, subtract disance (Y) from the distance listed.

Step 4. Use a tape measure to mark the appropriate distance on the WMK-027. This will be where the center of the mounting bracket will be located.

Calculations

X = Manufacturers recommended throw distance

Z = Distance from wall to face of whiteboard/screen

Front Lens Throw Distance =

(X + Y + Z)

Rear Lens Throw Distance =

(X - Y + Z)

Front Lens

Rear Lens

If installing WMK-027, please refer to Page 10 before continuing.

Page 8 Installation Instructions