V . C O M F O R T A D J U S T M E N T S
To adjust the headrest height:
1.Push in the headrest release button.
2.Move the headrest up or down to the desired position.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°. See figure 15.
To adjust the seatback angle:
1.Remove the seatback angle adjustment screws from both seat hinges.
2.Set the seatback at the desired angle.
3.Reinstall the screws to both seat hinges and tighten.
Armrest Width Adjustment
Youcanchangeeacharmrest’swidthindependentlyoftheother.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1.Locate the two armrest knobs on each side of the arm- rest receiver bracket. See figure 15.
2.Loosen the knobs.
3.Slide the armrests in or out to the desired width.
4.Tighten the knobs.
Armrest Height Adjustment
To change the armrest height:
1.Loosen the two setscrews located on the armrest receiver.
2.Raise or lower the armrest to the desired height.
3.Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicular to the floor.
2.Loosen the jam nut. See figure 15.
3.Loosen the armrest angle adjusting screw.
4.Turn the adjustment screw to raise the front of the arm- rest or to lower the front of the armrest. See figure 15.
5.Tighten the jam nut to lock the adjusting screw into place.
JAM NUT
ARMREST ANGLE
ADJUSTING SCREW
ARMREST HEIGHT
ADJUSTING
SETSCREWS
SEATBACK ANGLE
ADJUSTING SCREW
ARMREST KNOB
Figure 15. Seatback and Armrest Adjustments
Quantum 1122 Series | www.quantumrehab.com | 25 |
