Pride Mobility 1122 3SP, 1122 4MP manual Elevating Leg Rests Optional, Anti-Tip Wheel Adjustment

	V . C O M F O R T A D J U S T M E N T S
Elevating Leg Rests (Optional)
Elevating Leg Rests (ELRs) offer an infinite range of ad-
justment for the leg angle and a footrest adjustment range
of 12–19 in. (30.5–48.25 cm). See figure 21.		RELEASE LEVER A
To adjust the ELR angle:		RELEASE LEVER B
1.	Push down release lever B.	LEG REST
2.	Move the leg rest to the desired angle.
		EXTENSION
To rotate the ELR:
1.	Push in release lever A.	ADJUSTMENT
2.	Rotate the ELRs.	SCREWS
To adjust the ELR length:
1.	Remove the two screws from the side of each leg rest
	extension.
2.	Slide the leg rest in or out to the desired length.
3.	Reinstall the two screws on each leg rest extension.	Figure 21. Elevating Leg Rests

Anti-Tip Wheel Adjustment

The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either of the following occur:

!When coming to a stop, your power chair tips forward excessively.

!The anti-tip wheels constantly rub the ground.

WARNING! Consult your Quantum Rehab Specialist before attempting to change the anti-tip height! Changing the anti-tip wheel height affects handling under deceleration!

WARNING! The higher you raise the anti-tip wheels, the more tendency your power chair has to tilt forward when coming to a stop. You can compensate for this by making a small adjustment to the pre-programmed deceleration setting in the controller or by moving the seat assembly farther to the rear of your power chair.

PROHIBITED! Do not remove the anti-tip wheels from your power chair.

NOTE: Each drive tire must have at least 35 psi (2.4 bar) of air pressure in order for the anti-tip wheels to be properly adjusted.

To adjust the anti-tip wheels:

1.Place a wrench on the inner locknut of the anti-tip bracket located right after the shock strut. See figure 22.

2.Turn the locknut counterclockwise to loosen.

3.Place your wrench on the adjustable cam located on the other side of the locknut. See figure 23.

4.To adjust the anti-tip upward, turn the cam counterclockwise. To adjust the anti-tip downward, turn the cam clockwise.

28 www.quantumrehab.com Quantum 1122 Series