V . C O M F O R T A D J U S T M E N T S

Controller Position

You can move the controller in toward or out away from the armrest, or change the position of the controller for ei- ther left-hand or right-hand use.

WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.

To extend the controller:

1.Flip up the armrest so it is perpendicular to the floor.

2.Loosen the setscrew on the controller bracket. See figure 16.

3.Slide the controller into or out of the armrest to the desired position.

To change the controller position:

1.Turn off the power to the controller.

2.Unplug the controller connector from the power base.

3.Remove any wire ties securing the controller cable to the armrest.

4.Flip up the armrest so it is perpendicular to the floor.

5.Loosen the setscrew on the controller bracket.

6.Slide the controller out of the armrest.

7.Loosen the setscrew in the other armrest.

8.Place the controller in the other armrest.

9.Tighten the setscrew to secure the controller.

10.Route the controller cable to the back of the power base and plug in the controller.

11.Secure the controller cable to the armrest with wire ties.

NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or TRU-Balance Power Po- sitioning System, loosen the mounting screws in the mounting block, transfer the mounting block and con- troller to the opposite armrest, and tighten the mount- ing screws. See figure 17 .

CONTROLLER BRACKET

SETSCREW

Figure 16. Underside of Armrest

MOUNTING

SCREWS

SETSCREWS

Figure 17. Controller Position Mounting Bracket

26

www.quantumrehab.com

Quantum 1122 Series

Page 26
Image 26
Pride Mobility 1122 3SP, 1122 4MP manual Controller Position, To extend the controller, To change the controller position