Pride Mobility INFMANU3267 I . D I S a S S E M B L Y a N D a S S E M B L Y, Frame Separation

	V I I . D I S A S S E M B L Y A N D A S S E M B L Y
7.	Unfasten the battery tie-down strap and remove	REAR LIGHTING
8.	the batteries from the battery wells.	HARNESS
	Squeeze the tiller adjustment lever and lower
	the tiller to its lowest point. Adjust the tiller
	console if necessary.
	WARNING! Failure to unplug both
	battery harnesses, the front-to-rear
	harness, and rear lighting harness
	prior to separating the front and
	rear sections could result in
	permanent damage to the scooter.
Frame Separation
1.	Squeeze the tiller adjustment lever and lower
	the tiller to its lowest point.	BATTERY HARNESSES	FRONT-TO-REAR HARNESS
2.	Lift up on the frame release lever. See figure 23.
3.	Lift the front section up until the frame hooks of	Figure 22. Harness Connections
	the front section separate from the rear section.
	See figure 24.

NOTE: Stabilize the rear section with your free	FRAME RELEASE LEVER
	FRAME LOCK
hand by holding onto the upper frame tube. See
figure 24.

4. Slowly separate the two sections. See figure 24.

ASSEMBLY
1.	Position the front and rear sections of your
	scooter as shown in figure 24.
2.	Use the frame release lever to lift the front sec-
	tion as you align the frame hooks of the front
	section with the lower frame tube of the rear	FRAME HOOK
	section. See figure 23.
3.	Once the frame hooks are over the lower frame	Figure 23. Frame Release
	tube, lower the front section completely. This
4.	will engage the frame lock. See figure 23.	LOWER FRAME TUBE
	Raise the tiller.	UPPER FRAME TUBE
5.	Reinstall both batteries and secure with the tie-
	down strap, making sure the strap is positioned over
	the frame release lever to ensure proper securement.
6.	Connect the front-to-rear harness, rear lighting
	harness, and both battery harnesses. See figure 22.
7.	Reinstall the rear shroud.
8.	Reinstall the seat and rotate it into place.
9.	Unlock the front wheel by turning the tiller lock
	knob 90° counterclockwise. See figure 21A.
	WARNING! After assembly, make	FRAME HOOK
	absolutely certain the tiller lock
	knob is in the unlocked position	Figure 24. Frame Separation
	before riding your scooter.

Celebrity XL www.pridemobility.com 35