V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below develops.
NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has been turned off, then turned back on.
BEEP CODE | CONDITION |
| SOLUTION |
|
| ||
(1,1) | Controller is hot; the scooter seems to be | Shut down your scooter for a | |||||
| losing power. | minimum | of | several | minutes | to | |
| allow the controller to cool. |
|
| ||||
|
|
|
| ||||
|
|
| |||||
(1,4) | Battery charge is low. | Charge batteries as soon as possible. | |||||
(3,3) |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
(1,2) | Throttle pot fault. | Contact | your | authorized | Pride | ||
|
| Provider for assistance. |
|
|
| ||
(1,3) | Speed pot fault. | Contact | your | authorized | Pride | ||
|
| Provider for assistance. |
|
|
| ||
(1,5) | Attempting to operate the scooter with | Turn the scooter key to the off | |||||
| the charger attached. | position. Switch off the | charger | and | |||
| remove the cord from the charger port, | ||||||
|
| ||||||
|
| then restart your scooter. |
|
|
| ||
|
|
| |||||
(3,5) | Throttle control lever not at center | Return the throttle control lever to | |||||
| position at start up. | center position, | turn scooter | off, | and | ||
| then back on. |
|
|
|
| ||
|
|
|
|
|
| ||
|
|
| |||||
| The manual freewheel lever may be in the | Turn the scooter key to the off | |||||
(3,4) | freewheel (forward) position. | position. Push the freewheel lever to | |||||
| the drive (backward) position, then | ||||||
|
| ||||||
|
| restart your scooter. |
|
|
| ||
|
|
|
|
|
| ||
(3,2) | A brake fault has occurred. | Contact | your | authorized | Pride | ||
|
| Provider for assistance. |
|
|
| ||
What if all the systems on my scooter seem to be “dead”?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Scooter.”
Make certain that both battery harnesses and the
Be sure the power down timer feature hasn’t been activated. See V. “Operation.”
36 | www.pridemobility.com | Celebrity XL |
