I X . C A R E A N D M A I N T E N A N C E
10. Reinstall the drive wheel nut and washer onto the axle and tighten.
WARNING! Make sure both the nut and washer are reinstalled and tightened properly.
11.Inflate pneumatic tires to the psi/bar/kPa air pressure rating indicated on each tire.
12.Remove the block from beneath the scooter.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized Pride Provider repair or replace any damaged connector, connection, or insula- tion that you find before using your scooter again.
ABS PLASTIC SHROUDS
The shrouds of the scooter are formed from durable ABS plastic and are coated with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
NYLON LOCK NUT REPLACEMENT
Any nylon insert lock nut removed during the periodic maintenance, assembly or disassembly of the scooter must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or through your authorized Pride Provider.
FUSE REPLACEMENT
To replace a fuse:
1.Remove the fuse by pulling it straight out of its slot.
2.Examine the fuse to be sure it is blown. See figures 27 and 27A.
3.Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the fuse being replaced. Failure to use properly rated fuses may cause damage to the electrical system.
Figure 27. Working Fuse | Figure 27A. Blown Fuse (Replace) |
40 | www.pridemobility.com | Celebrity XL |
