Basic Operation Instructions | 17 |
|
|
To unlock the Dynamic controller:
1.While the Dynamic controller is locked, press the on/off key to turn on the controller. All LEDs will flash briefly. The LEDs will then slowly ripple from right to left.
2.Press the horn key twice before the LED ripple has completed, approximately 10 seconds. The controller is now unlocked.
NOTE: If you do not press the horn key twice before the countdown is complete, the system will beep and the Dynamic controller will turn itself off. The unlock sequence must be completed successfully before the Dy- namic controller will operate again.
ACTUATOR ADJUSTMENT
The Dynamic controller can control two actuators using the mode key and the joystick. The active actuator is indicated by an illuminated actuator LED. See figure 4, 5, or 6.
To select and adjust an actuator:
1.Press the on/off key to power on the controller.
2.Press the actuator select key once to select ActuatorAdjustment Mode.Actuator 1 will be active as noted by the amber “1” indicator.
3.Push the joystick to the right or press the actuator select key again to cycle through the available actuators. The actuator indicators will display which actuator is activated. See figure 7.
4.When the desired actuator is selected, give a forward command to the joystick to raise the actuator or give a reverse command to the joystick to lower the actuator.
5.Press the actuator select key again to return to the Drive Mode.
Figure 7. Actuator
Indicators (None, Actuator
1, and Actuator 2 Shown)
www.pridemobility.com | Dynamic Controller |
