Pride Mobility INFMANU3676 Sleep Mode if Enabled, OUT of Neutral AT Power UP Oonapu, Error Codes

18 Basic Operation Instructions

SLEEP MODE (IF ENABLED)

The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main power if the joystick is not moved in any direction for a period of time. This time factor is programmed into the controller. To restore power and continue, push any key on the keypad.

OUT OF NEUTRAL AT POWER UP (OONAPU)

Your power chair joystick is equipped with Out Of Neutral At Power Up (OONAPU). If you power up the system and the joystick is not in the neutral position, all of the lights in the speed setting indicator will flash rapidly for as long as the joystick is out of the neutral position. Allow the joystick to return to the neutral position and the fault will clear.

ERROR CODES

The service indicator will flash error codes when the Dynamic controller detects an abnormal condition in the electrical system. The service indicator will flash a num- ber of times quickly, then pause, then flash again. The service indicator will con- tinue to flash the error codes until the problem is fixed. The following table identi- fies the individual error codes. If any of these error codes persist or if you experi- ence any other problem with your power chair, contact your authorized Pride Provider.

NOTE: When the service indicator flashes an error, the battery condition meter LEDs will also flash an inhibit. See “Battery Condition Meter.”

Dynamic Controller www.pridemobility.com