Pride Mobility INFMANU3890 manual Follow these easy steps to charge the batteries

I V . B A T T E R I E S A N D C H A R G I N G

Follow these easy steps to charge the batteries:

1.Position the front of your scooter close to a standard electrical outlet.

2.Remove the key from the key switch.

3.Make sure that the manual freewheel lever is in the drive position.

4.Plug the 3-pin charger power cord into the off- board charger port. See figures 5 and 11.

5.Extend the charger power cord and plug it into the electrical outlet. We recommend that you charge the batteries for 8 to 14 hours.

6.When the batteries are fully charged, unplug the charger power cord from the electrical outlet and then from the off-board charger port.

PLUGS INTO THE OFF-BOARD

CHARGER PORT

PLUGS INTO ELECTRICAL OUTLET

Figure 11. Off-board Charger

NOTE: The LED lights on the charger indicate different charger conditions at various times: charger power on, charging in progress, charging complete. Refer to the manual supplied with the charger for a complete explanation of these indicators.

NOTE: There is a charger inhibit function on your scooter. The scooter will not run and the battery condition meter will not operate while the batteries are charging.

FREQUENTLY ASKED QUESTIONS

How does the charger work?

When your scooter’s battery voltage is low, the charger works harder, sending more electrical current to the batteries to bring up their charge. As the batteries approach a full charge, the charger sends less and less electrical current. When the batteries are fully charged, the current sent from the charger is at nearly zero amperage. Therefore, when the charger is plugged in, it maintains the charge on your scooter’s bat- teries, but does not overcharge them. Refer to the manual supplied with the battery charger for charging instructions.

Can I use a different charger?

Chargers are selected precisely for particular applications and are especially matched to the type, size, and chemical formulation of specific batteries. For the safest and most efficient charging of your scooter’s batteries we recommend only use of the charger supplied as original equipment with your Pride product. Any charging method resulting in batteries being charged individually is especially prohibited.

What if my scooter’s batteries won’t charge?

Ensure the red (+) and black (-) battery cables are connected properly to the battery terminals. Ensure both battery harnesses that extend from the batteries are plugged into their mating harness. Ensure both ends of the charger power cord are inserted fully.

Pursuit www.pridemobility.com 25