V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the prob- lems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FAULT CODES
The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly and easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below develops.
NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has been turned off, then turned back on.
FAULT CODE | CONDITION | SOLUTION |
|
|
|
(1) | Battery charge is low. | Charge batteries as soon as possible. |
|
|
|
(2) | Battery charge is too low. | Charge batteries. |
|
|
|
(3) | The scooter's battery voltage is too | Unplug charger and/or turn key off, |
| high to operate the scooter, or the | then back on again. |
| charger is still connected to the off- |
|
| board charger port. |
|
|
|
|
(4) | Current limit time out. | Turn the scooter off for a few min- |
|
| utes, then turn your scooter back on. |
|
|
|
(5) | The manual freewheel lever is in the | Remove the key from the key |
| (forward) freewheel position. | switch, then push the manual free- |
|
| wheel lever to the drive (rearward) |
|
| position and restart your scooter. |
|
|
|
(6) | Throttle control lever not at center | Return the throttle control lever to |
| position at start up. | center position, turn scooter off then |
|
| back on. |
|
|
|
(7) | Speed pot error. | Call your authorized Pride Provider for |
|
| assistance. |
|
|
|
(8) | Motor volts error. | Call your authorized Pride Provider for |
|
| assistance. |
|
|
|
(9) | Other internal errors. | Call your authorized Pride Provider for |
|
| assistance. |
|
|
|
What if all the systems on my scooter seem to be dead? Make certain that the key is in the “on” position. Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Scooter.”
Make certain that both battery harnesses and the
Be sure the power down timer feature has not been activated. See V. “Operation.”
Pursuit | www.pridemobility.com | 35 |
