Pride Mobility INFMANU4440 manual Safety Flag Bracket Optional, To install the flag

	I I I . Y O U R S C O O T E R
Safety Flag Bracket (Optional)
An accessory bracket for installing an optional safety
flag is mounted near each anti-tip wheel and also on				HEX KEY
the seatback hinge. To install the flag to the rear				CAP
frame, use the smaller of the two supplied “L” shaped
hex keys. To install the flag to the seat hinge, use the				SETSCREW
larger hex key. See figure 8.
To install the flag:
1. Remove the cap from the top of the bracket.
2. Loosen the setscrew with the supplied “L”
shaped hex key.
3. Insert the flag pole into the opening.
4. Tighten the setscrew to complete installation.
Manual Freewheel Lever				Figure 8. Safety Flag Bracket
Whenever you need or want to push your scooter for
short distances, you can put it in freewheel mode.
Remove the key from the key switch.				MAIN CIRCUIT BREAKER (RESET BUTTON)
Push forward on the manual freewheel lever to
disable the drive system and the brake system.
You may now push your scooter.
Pull back on the manual freewheel lever to
reengage the drive and the brake systems and
take your scooter out of freewheel mode.
WARNING! When your scooter is in
freewheel mode, the braking system
is disengaged.
Disengage the drive motors only
on a level surface.
Ensure the key is removed from
the key switch.				Figure 9. Main Circuit Breaker Reset Button
Stand to the side of the scooter
to	engage	or	disengage
freewheel mode. Never sit on a
scooter to do this.
After you have finished pushing

your scooter, always return it to the drive mode to lock the brakes.

NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in the “on” position, the scooter will not run until the manual freewheel lever is pushed backward and the key is turned to the “off” position, then back to the “on” position.

22 www.pridemobility.com Celebrity X LE