Pride Mobility INFMANU4440 manual How do I change a battery in my scooter?

Figure 13. Battery Harnesses and Battery Cables

I V . B A T T E R I E S A N D C H A R G I N G

NOTE: Sealed batteries are not serviceable. Do not remove the caps.

How do I change a battery in my scooter?

MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Always use two batteries of the exact same type, chemistry, and amp-hour (Ah) capacity. Refer to the specifications table in this manual and in the manual supplied with the battery charger for recommended type and capacities.

WARNING! Contact your authorized Pride Provider if you have any questions regarding the batteries in your scooter.

WARNING! Do not replace the batteries while the scooter is occupied.

WARNING! Do not mix old and new batteries. Always replace both batteries at the same time.

WARNING! The batteries on your scooter should only be serviced or replaced by an authorized Pride Provider or a qualified technician.

PROHIBITED! Keep tools and other metal objects away from battery terminals. Contact with tools can cause electrical shock.

You may need the following to change your batteries:

„ Metric/standard socket set and ratchet „ Adjustable wrench

To change the batteries in your scooter:

WARNING! Do not lift beyond your physical capability. Ask for assistance when necessary while disassembling or assembling your scooter.

1.Remove the seat and rear shroud. See VII. “Disassembly and Assembly.”

2.Disconnect the battery tie-down strap.

3.Disconnect the battery harnesses by pulling them straight up. See figure 13.

4.Disconnect the battery cables from the battery terminals.

5.Remove the old batteries.

6.Place a new battery in each battery well. Face the battery terminals toward the seat post.

7.	Connect the red battery cable to the positive (+)
8.	battery terminal. See figure 13A.	BATTERY HARNESSES	TERMINAL BOOTS
	Connect the black battery cable to the
	negative (-) battery terminal.
9.	Ensure the battery terminals are covered with
	the tiller boots.

NOTE: See figure 13B for correct hardware placement for battery terminal connections.

10. Reconnect the battery harnesses.

11. Reconnect the battery tie-down strap, making sure the strap is positioned over the frame release lever to ensure proper securement. See

figure 13C.

12. Reinstall the rear shroud and seat.

Celebrity X LE www.pridemobility.com 27