V I I I . O P E R A T I O N
On/Off Key
The on/off key turns the VSI on and off.
WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the chair. This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are stationary to prevent unexpected movement.
Battery Condition Meter
The battery condition meter is located in front of the joystick. This is a
νRed, yellow, and green lights lit: Battery charged; VSI and electrical system OK.
νRed and yellow lights lit: Charge battery if possible; VSI
and electrical system OK.
ν Red lights only lit or slow flash: Charge battery as soon as possible; VSI and electrical system OK.
νRapid flash of lights: Indicates a fault in the VSI or the electrical system. Refer to “VSI Error Codes.”
νRipple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you get “ripple up and down of lights”, turn off the controller, allow the joystick to return to the neutral position, then turn on the controller.
NOTE: If you still get “ripple up and down of lights”, contact your authorized Pride provider.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding you the batteries need to be charged immediately!
Speed/Profile Keys
There are two keys that control either the speed or the profile. This depends on how your VSI was programmed. Press the speed/profile increase key to increase the speed or change the profile. Press the speed/profile decrease key to decrease the speed or change the profile. The speed/profile setting is displayed on the maximum speed/profile indicator. If your power chair was programmed with a drive profile, contact your authorized Pride provider for more information.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the slowest setting until you become familiar with your new power chair.
Jazzy 1133 Owner’s Manual Rev B | www.pridemobility.com | 33 |
