Pride Mobility JAZZY 1121, JAZZY 1101 C O M F O R T a D J U S T M E N T S, Comfort Adjustments

BALL DETENT PINS

STEEL TOWERS Figure 9. 1101/1121 Seat Height Adjustment

V I . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your Jazzy’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height and angle, armrest angle, footrest height and angle, and the controller’s position. If your Jazzy is equipped with a Synergy Seat or the Versa Tilt, refer to the information provided in separate manuals. If your Jazzy is equipped with a medium-back seat, a high-back seat, a reclining seat, or a power elevating seat, refer to the following information.

WARNING! If your Jazzy was configured at your authorized Pride Provider, please consult your healthcare professional before changing the seat position or making any other adjustment. Some adjustments may degrade your Jazzy’s performance and safety by changing its center of gravity.

You may need the following to make comfort adjustments:

νmetric/standard hex key set

νmetric/standard socket set and ratchet

νadjustable wrench

Seat Height and Seat Angle Adjustment

There are four steel towers that connect the seat to the power base. See figures 3 and 9. You can change the seat height to one of three positions in 1-in. increments by raising the seat towers. If you raise or lower only one set of seat towers (front or rear), you can also change the seat base angle. If your

Jazzy is equipped with a power elevating seat, then you change the seat height through the controller or a switch.

To change the seat height or seat angle:

1.Remove the ball detent pin from each of the four seat towers.

2.Raise or lower each seat pin to the desired position.

To change the angle, set either the front or rear seat towers higher or lower than the other.

3. Reinstall the ball detent pin into each seat tower.

Seat Position

You can move the seat forward or rearward by changing the extrusion mounting position.

To change the position:

1.Remove the seat.

2.Remove both extrusions from the bottom of the seat. See figure 7.

3.Reposition the extrusions on a different set of mounting holes. See figure 10.You must move both extrusions the same number of holes either forward or backward.

4.Fasten the extrusions back onto the bottom of the seat.

5.Reinstall the seat.

Reclining Seat

If your Jazzy is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base.

Jazzy 1101/1121/RevE/Jun03 www.pridemobility.com 21