V I I I . O P E R A T I O N

Actuator Keys and Actuator Lights (For Optional Equipment)

Actuator keys and actuator lights are used for optional equipment such as power elevating seats or power elevating leg rests. For specific operation of the actuator keys and actuator lights, contact your authorized Pride Provider.

Horn Key

The horn key activates the horn.

Locking/Unlocking the VSI

The VSI has a feature that enables you to lock your power chair to prevent unauthorized use.

To lock the VSI:

1.With the VSI switched on, press and hold the on/off button. After 1 second, the VSI should beep.

2.Release the on/off button.

3.Push the joystick to the full forward position until the VSI beeps.

4.Pull the joystick to the full rearward position until the VSI beeps.

5.Release the joystick. There should be a long beep.

6.The VSI is now locked.

To unlock the VSI:

1.Press the on/off button and power on the VSI. The maximum speed/profile indicator should ripple up and down.

2.Push the joystick to the full forward position until the VSI beeps.

3.Pull the joystick to the full rearward position until the VSI beeps.

4.Release the joystick. There should be a long beep.

5.The VSI is now unlocked.

NOTE: If the above procedure fails to either lock or unlock the VSI, contact your authorized Pride Provider.

Off-board Charger/Programming Socket

The off-board charger/programming socket is located on the front of the VSI. If you use an off-board charger, the charger current should not exceed 12 amps. Contact your authorized Pride Provider for more information.

CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/ programming socket. See your authorized Pride Provider for more information.

Actuator Connector

The actuator connector connects the VSI to optional powered systems such as an elevating seat or lighting system.

Controller Connector

The controller connector connects the VSI to the power chair’s batteries, motors, and motor brakes.

Charger Inhibit Connector

The charger inhibit connector connects the VSI to the onboard battery charger. This connection provides an inhibit that disables the VSI when the battery charger is on. The charger inhibit connector is coded with colored dots. The dots are positioned so that you align the flat side of the male connector with the flat side of the female connector before making the connection.

34

www.pridemobility.com

Jazzy 1101/1121/Rev E/Jun03

Page 34
Image 34
Pride Mobility JAZZY 1101 Actuator Keys and Actuator Lights For Optional Equipment, Horn Key, Locking/Unlocking the VSI