V I . C O M F O R T A D J U S T M E N T S
Seat Position
You can move the seat forward or rearward by changing the ex- trusion mounting position.
To change the seat position:
1.Turn off the power to the controller.
2.Unplug the controller connector from the power base.
3.Remove the seat from the power base.
4.Remove both extrusions from the bottom of the seat.
5.Reposition the extrusions on a different set of mounting holes. You must move both extrusions the same number of holes either forward or backward. See figure 23.
6.Fasten the extrusions back onto the bottom of the seat.
7.Reinstall the seat.
8.Plug the controller connector into the power base.
Manual Recline Seatback Adjustment
If your power chair is equipped with an optional reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base.
To adjust the seatback angle:
1.Pull up on the seatback release lever.
2.Move the seatback down or up to the desired position.
3.Release the lever.
Headrest Adjustment
If your power chair is equipped with the optional
To adjust the headrest height:
1.Push in the headrest release button.
2.Move the headrest up or down to the desired position.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1.Remove the seatback angle adjustment screws from both seat hinges. See figure 24.
2.Set the seatback at the desired angle.
3.Reinstall the screws to both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
Figure 23. Seat Mounting Holes
JAM NUT |
ARMREST |
ANGLE |
ADJUSTMENT |
SCREW |
ARMREST |
HEIGHT |
ADJUSTING |
SETSCREWS |
SEATBACK |
ANGLE |
ADJUSTMENT |
SCREW |
ARMREST KNOB |
Figure 24. Seatback/Armrest Adjustment
Jazzy Select 7 | www.pridemobility.com | 29 |
