V . S E R V I C E
Assembly
To assemble the power chair:
1.Place the three frame assemblies next to each other as shown in figure 20.
2.Grasp the front frame and fit the notch on the front frame bottom bar onto the locating pin on the lower section of the power base frame assembly.
WARNING! The front frame should be positioned with the two semicircular notches in the vertical bar facing forward.
3.Pivot the front frame top bar toward the power base frame assembly and push the front frame top bar onto the locking mechanism until the two assemblies snap securely into place. See figure 18.
4.Repeat steps
WARNING! Make certain that the front frame is snapped securely to both the right frame assembly and to the left frame assembly.
5.Hold the battery well frame so that the bottom of the well hangs downward.
6.Position the notches on the front of the battery well frame onto the locating pins on the front frame bottom bar. See figure 21.
7.Fit the notch on either side of the rear of the battery well frame onto the locating pin on each power base frame assembly.
8.Make certain that the locking mechanisms snap securely into place.
9.Reinstall the service disassembly bracket. See figure 17.
NOTE: The service disassembly bracket must be reinstalled as the chair is reassembled after service.
10.Place the front battery box into the front end of the battery well frame.
NOTE: Make certain that the connectors are facing toward the center of the power chair.
11.Place the rear battery box into the back end of the battery well frame. Make certain that none of the wiring harnesses or cables are pinched between the battery or the motor controller box and the frame.
12.Connect the battery boxes.Use the battery connection label located on the back of the electronics tray for reference.
Figure 18. Removing Battery Well Frame
Figure 19. Power Base Frame Removal/ Installation
26 | www.pridemobility.com | Jazzy Select 7 |
