Prince Castle operation manual TOASTER TX-208, Upper Latch Lower Latch

TOASTER TX-208

6 Release the upper and lower locking latches from the conveyor rollers.

Upper Latch

Lower Latch

8 Remove the plastic spline from the belt.

Place the belt (orange surface up) on a flat surface. Clean the

9 belt orange surface with a mild dishwashing detergent (CAPITAL used to clean trays works well. Mix 1 part CAPITAL to 9 parts water). Spray detergent onto orange portion of belt, then wait

1 minute for residue to dissolve. Spray detergent onto a no-scratch pad and wipe the belt to remove residue. When the belt is clean, the surface will have a tacky grip when you rub a finger over the surface. Sanitize the surface by wiping it with a cloth damp with tray sanitizing liquid (Kay-5 Sanitizer).

Residue on the belt is easy to remove if it is still oily. If the residue has formed a slick coating, additional scrubbing effort is required to remove it.

The conveyor belt has only one contact surface and must be re-installed with orange side facing out.

Place the release sheet on a flat surface. Clean the release sheet with a mild dishwashing detergent (CAPITAL used to clean trays works well). Sanitize the surface by wiping it

with a cloth damp with tray sanitizing liquid (Kay-5 Sanitizer).

The Teflon sheet uses both sides as the contact surface. When re- installing, rotate the usage by turning top-to-bottom and/or turning the sheet inside/out.

7	Remove the conveyor belt.
	Rotate the belt while removing

it from the side of the unit.

Reassemble the unit by

10 reversing steps 1 - 8.

When reassembling convey- or belt, make sure plastic spline is positioned correctly as shown.

When reassembling release sheet, be sure to install upper and lower retaining bars in the correct end.

Release Sheet

Upper Retaining Bar

Release Sheet

Lower Retaining Bar

TX-208 537-511revB 5 Printed in USA 0324 © 2003