Prince Castle TX-208 Toaster, Problem, Possible Cause, Corrective Action, Troubleshooting

		TOASTER
		TX-208
	Troubleshooting
Problem	Possible Cause	Corrective Action
Unit will not heat up.	No power to unit.	Make sure power cord plugged into the unit and
		proper electrical receptacle.
	Inoperable power cord.	Replace power cord.
	Loose connection on power switch.	Tighten power switch connections.
	Inoperable power switch.	Replace power switch.
	High limit switch tripped.	Reset limit switch. Using a pencil or pen, press
		the hollow portion of the 3/8" long brown, plastic
		stem located at the right-hand rear of the unit.
		Allow the unit to cool (approximately 15 min-
		utes) before starting.
Unit heats up but conveyor	Loose motor connection.	Tighten motor connection.
will not run.	Inoperable motor.	Replace motor.
	Stripped drive gear.	Replace drive gear.
	High limit switch tripped.	Reset limit switch. Using a pencil or pen, press
		the hollow portion of the 3/8" long brown, plastic
		stem located at the right-hand rear of the unit.
		Allow the unit to cool (approximately 15 min-
		utes) before starting.
Buns under or over done.	Check bun crush setting.	Adjust for proper compression.
	Verify setpoint temperature.	Adjust setpoint for proper temperature.
	Dirty teflon sheet.	Clean or replace teflon sheet.

When the platen temperature drops 24° or more below the setpoint temperature, the display will switch from RDY to LO. If the dis- play remains at LO for 30 minutes, contact an authorized Prince Castle Service Agent.

To extend the life of the motor, add 2-3 drops of high-temperature oil on a monthly basis. This task can be performed by an authorized technician.

L O

Oil Port

TX-208 537-511revB 7 Printed in USA 0324 © 2003