TOASTER
Daily Cleaning
WARNING
Before performing any maintenance, press the power switch to the OFF position. If the heater is above 450°F, the display will alternately show “COOL” and “OFF”, and the conveyor belt will continue to run approximately 45 minutes. When the unit has cooled sufficiently, the display will go blank and the conveyor motor will turn off.
Unplug the power cord from the electrical receptacle.
CAUTION
This unit is not watertight. Do not clean with a water jet or jet spray. Do not immerse the unit in water.
1.Turn the unit off and unplug the power cord from the electrical receptacle.
2.Wipe all stainless parts and unit with a damp cloth. DO NOT use a green scotch bright pad cleaner, ice or water.
General
• As buns are toasted, they leave an oily residue buildup on the conveyor belt and Teflon release sheet.
• Over a period of time, the residue will form a slick coating where buns make contact on the belt surface.
• If this slick coating is not removed, the belt may not pull the buns into the toaster or will not pull the buns completely through the toaster, and the buns will burn.
1 | Press the On/Off Button to turn the unit off. |
If the heater is above 450°F, the display will alternately show “COOL” and “OFF”, and the convey- or belt will continue to run approx- imately 45 minutes. When the unit has cooled sufficiently, the display will go blank and the conveyor motor will turn off.
Unplug the power cord from the electrical outlet.
3 | Remove the lower retaining bar from the release sheet and pull | |
the release sheet up thru the top of the unit. Remove the upper | ||
| retaining bar from the release sheet. |
|
| Lower Retaining Bar | Remove release sheet |
4 | Loosen the thumbscrews |
and remove the side panel. |
Thumbscrews 
5 | To release tension on the conveyor belt, |
press in and down on the roller. |
| Power On/Off Button |
2 | Remove the front cover by pulling up and off the unit. |
Set the cover aside. |
Front Cover
4 | Printed in USA 0324 © 2003 |
