Printek MtP300 Character Size and Line Spacing

Printek Emulation
Transmitter Off (Transmitted by Printer, Serial Only) XOFF (DC3)
When enabled for the Serial Interface (refer to the Operator’s Manual), this character is transmitted by the
printer to indicate that the printer’s input buffer is nearly full and that the host computer should stop sending
data. When the printer is able to accept data again, it will transmit DC1/XON.
Control Code: XOFF
Hexadecimal: 13
Character Size and Line Spacing
Select Character Pitch ESC K n
Sets the character pitch according to the following table.
Columns Per Line
n Character Pitch/Font Matrix MtP300 MtP400
0 5.5 cpi Sans Serif 37 x 60 13 22
1 10.2 cpi Sans Serif 20 x 26 28 41
2 10.7 cpi Sans Serif 19 x 26 30 43
3 12.7 cpi Courier 16 x 23 36 52
4 13.5 cpi Courier 15 x 23 38 55
5 14.5 cpi Courier 14 x 23 41 59
6 15.6 cpi Courier 13 x 23 44 64
7 16.9 cpi Courier 12 x 23 48 69
8 18.5 cpi Courier 11 x 23 52 75
9 20.3 cpi Courier 10 x 23 57 83
10 22.6 cpi Courier 9 x 23 64 92
11 25.4 cpi Courier 8 x 23 72 104
This command must be sent prior to any printable characters on the line. If sent after printable characters are
received, a Carriage Return and Line Feed will be inserted and a new line started before the command takes
effect.
Example: The following escape sequence will set the printer to use the 12.7 cpi Courier font.
Escape Sequence: ESC K 3
Hexadecimal: 1B 4B 03
Set Printer to 12.7 cpi SO
Sets the character size to 12 cpi. This is equivalent to sending ESC k 1.
This command must be sent prior to any printable characters on the line. If sent after printable characters are
received, a Carriage Return and Line Feed will be inserted and a new line started before the command takes
effect.
Control Code: SO
Hexadecimal: 0E
7