Vacuuming The Printer
71
CAUTION
The transfer charger must be in the down position to avoid
scratching the drum. Failure to perform steps 9 and 10
damages the drum.
9. Check that the transfer charger is in the down position, and if
not, move it to the down position by rotating the transfer
elevator drive shaft counterclockwise. Watch the charger
movement:
a. If the charger starts to move up, it is already in the down
position.
b. If the charger starts to move down, continue to rotate the
drive shaft until the charger reaches the complete down
position.
10. Lower the transport surface by turning the green lever on the
transport unit to the left.
Legend:
1) Transport Surface
2) Green Lever
3) Vacuum
11. Pull the transport unit toward you until it stops.
12. Using a vacuum, clean up the toner, paper dust, etc. Be sure to
clean under the transport unit as well.
13. Wipe off the dirt on the transport surface with wet tissue paper.
1
2
3