WARNING: Maintain the minimum clearances shown i n F i g u r e 4 . I f y o u c a n , provide greater clearances from floor, ceiling, and joining wall.
Figure 4
FASTENING HEATER TO WALL Mounting Bracket
The mounting bracket is located on back panel of heater (see Figure 5). It has been taped there for shipping. remove mounting bracket from back panel.
Figure 5 -Mounting Bracket
Location
INSTALLATION
Removing Lower Front Panel Of Heater
1.Remove two Screws near bottom corners of lower front panel.
2.Pull bottom of lower front panel forward, then down (see Figure 6).
Figure 6 - Removing Lower Front Panel Of Heater
Methods For Attaching Mounting Bracket To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. Attach mounting bracket to wall only in one of two ways:
1.Attaching to wall stud
2.Attaching to wall anchor Attaching to Wall Stud: This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to Wall Anchor: This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make
s u r e m o u n t i n g b r a c k e t i s level.
WARNING: Maintain mini- mum clearances shown in Fig- ure 8. If you can, provide greater
c l e a r a n c e s f r o m f l o o r and joining wall.
2. Mark screw locations on wall. (see Figure 7)
Note: Only mark last hole on
each end of mounting bracket. In- sert mounting screws through these holes only.
3.Remove tape and mounting bracket from wall.
Figure 7 - Mounting Bracket Clearances
7