Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws, and spacers are in hardware package. The hardware package is provided with heater.
Attaching to Wall Stud Method For attaching mounting bracket to wall studs
1.Drill holes at marked locations using 9/64" drill bit.
2.Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.
3.Insert mounting screws through bracket and into wall studs.
4.Tighten screws until mounting
bracket is firmly fastened to wall studs.
Attaching to Wall Anchor Method For attaching mounting bracket to hollow walls (wall areas between studs) or solid walls (concrete or masonry)
1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1" deep.
2.Fold wall anchor as shown in Figure 9 below.
Figure 9 - Folding Anchor
3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.
4.For thin walls (1/2" or less), insert red key into wall
anchor. Push red key to "pop" open anchor wings. (see Figure 10)
INSTALLATION
IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.
Figure 10 - Popping Open Anchor Wing For Thin Walls
5.Place mounting bracket onto wall. Line up last hole on each end of bracket with wall anchors.
6.Insert mounting screws through bracket and into wall anchors.
7.Tighten screws until mounting bracket is firmly fastened to wall.
Placing Heater On Mounting Bracket
1.Locate two horizontal slots on back panel of heater (see Figure 11).
2.Place heater onto mounting bracket. Slide horizontal slots onto
Figure 11 - Mounting Heater Onto Mounting Mracket
Installing Bottom Mounting Screw
1.Locate bottom mounting hole. This hole is near bottom
on back panel of heater (see Figure 12).
Figure 12 - Installing Bottom Mounting Screw
2.Mark screw locations on wall.
3.Remove heater from mounting bracket.
4.If installing bottom mounting screw into hollow or solid wall, install wall anchors. Follow steps
1 through 4 under Attaching To Wall Anchor Method. If installing bottom mounting screw into wall stud, drill hole at marked locations using 9/64" drill bit.
5.Replace heater onto mounting bracket.
6.Place spacer between bottom mounting holes and wallanchor or drilled hole.
7.Hold spacer in place with one hand. With other hand, insert mounting screw through bottom mounting hole and spacer. Place tip of screw in opening of wall anchor or drilled hole.
8.Tighten screw until heater is firmly secured to wall. Do not over tighten.
•Note: Do not replace lower front panel at this time. Replace lower front panel after making gas connections and checking for leaks (see page 9).
8
